Stepper Driver RSS Feed

Currently, all of our stepper drivers only used in Hybrid stepper motors. As PM stepper motor’s current is very small, and the precision is not high, the lower cost chips driver is the best choice. ..

Below are the main difference for T, Y, S and N series drivers: Series Series T Series Y Series S Series N Product Levels High-performance High cost performance Standar..

Our answer is yes. We have tested all of drivers in our company, and the results are ok. But we are still not recommended it, because the main components’ supplier declare the working voltage is 4.5~5..

Please follow below steps to connect stepper driver to Arduino: 1. Connect driver’s DIR+ and PUL+ to Arduino’s digital port. eg. PIN8 and PIN9. 2. Connect PUL- and DIR- to Arduino’s GND. 3. Write prog..

1.Usually, the stepper drivers matching the motors are listed on related products column, which is placed on the right side of the website. 2.Regarding open-loop stepper motor, it is fine to select ..

Firstly, CL57T is stepper driver, not a controller. As a stepper driver, it don’t have any controlling function. Secondly, for debugging purpose, this driver can be debugged through RS232, you can mod..

Sorry, you can not use closed loop stepper driver to drive a open loop stepper Motor. Below are the driver and motor’s relation between closed loop and open loop. Open Loop Motor Closed..

For closed-loop driver, below parameters can be debugged: Peak Current Rated current of motor * 1.414 Closed-loop holding current percentage Normally set 45%（rated current） Position tracking e..