Digital Stepper Driver Low Speed Arduino Low Control Signal Voltage 3.3V-5V Current 1.4-5.6A 15-36VAC/20-50VDC for Nema 17, 23, 24 Stepper Motor

     1 reviews  |  Write a review
SKU: DM556N-L
$27.50 $35.75

Bulk quantity price break:

Qty 5 10 50 100
Price $24.75 $23.38 $22.00 $20.63
Save 31% 35% 38% 42%
Availability: 224

Qty

askquestion

The DM556N-L is a fully digital stepper driver developed with advanced DSP control algorithm based on the latest motion control technology. It is especially effective in devices where users expect low cost, low noise. Its motor auto-identification and parameter auto-configuration feature offers quick setup to optimal modes with different motors.

Key Features:

  • Low control signal voltage, from +3.3V to 5V
  • Low noise, low motor speed
  • Average current control, two-phase sinusoidal current output
  • The servo microstep DSP algorithm, low noise, low vibration
  • The max. power supply voltage can be 40VAC / 50VDC
  • Output motor current (peak) from 1.4A to 5.6A
  • The standstill current can be set to half
  • Can drive 4, 6 and 8 wire two-phase, four-phase stepper motors
  • High-speed optocoupler isolation signal input, pulse response frequency up to 200 kHz
  • Strong anti-high frequency interference ability
  • Easy to set output current
  • Microstep accuracy: 2, 4, 8, 16, 32, 64, 128, 5, 10, 20, 25, 40, 50, 100, 125
  • Overvoltage, undervoltage, overcurrent, and phase-to-phase short circuit protection
  • The max motor speed: 500RPM. (Recommend value: 200RPM). If you need higher motor speed, recommend DM556T

Electrical Specifications:

  • Input Voltage: 20 ~ 50VDC / 15 ~ 40VAC (Typical value: 36 VDC / 24VAC)
  • Output Peak Current: 1.4 ~ 5.6A
  • Max Pulse Frequency: 200KHz
  • Control Signal Voltage: +3.3 ~ 5VDC
  • Control Signal Current: 7 ~ 16mA
  • Isolation Resistance: 500MΩ

Operating Environment and other Specifications:

  • Cooling: Netural Cooling or Forced Cooling
  • Environment: Avoid dust, oil fog and corrosive gases
  • Ambient Temperature: 0℃ ~ 50℃
  • Humidity: 40 ~ 90% RH
  • Maximum Operating Temperature: 70℃
  • Vibration: 10 ~ 55Hz / 0.15mm
  • Storage Temperature: -20℃ ~ 125℃
  • Weight: Approx. 280g (9.88oz)

Resources

Stepper Driver Specification
Input Voltage(V) 20 - 55VDC/15 - 36VAC
Output Current(A) 1.4 - 5.6
Microstep(Steps/rev.) 400 - 25600
Max. Pulse Input(kHZ) 200
Pulse Width(μs) 2.5
Physical Specification
Weight(g) 276

Do you have any questions about Digital Stepper Driver Low Speed Arduino Low Control Signal Voltage 3.3V-5V Current 1.4-5.6A 15-36VAC/20-50VDC for Nema 17, 23, 24 Stepper Motor?

Captcha